Thermionic Culture product names follow a distinctly avian theme and so it continues with this unit, the Rooster, which provides dual valve based preamps and EQ with 'attitude' courtesy of a distortion function first used in the Culture Vulture.

There are two Rooster models available, one with unbalanced outputs (on review here) and the other with transformer balanced outputs for around £180 more.

The Rooster carries all the hallmarks of the Thermionic Culture aesthetic across its 2U front panel: gloss black finish, neat white legending, quality knobs and switches, and a large green power light. The Rooster presents a well laid out control surface that flows logically from left to right, and with plenty of room between switches and knobs it is very easy to work with.

On each channel the initial phase invert and mic/line selector switches are followed by the 1/4-inch DI input jack and input gain knob, which as with all TC gear goes up to 11. The proceeding EQ section is made up of a Bass Lift knob, a Mid/Hi Lift knob with a frequency selection switch, a Mid Cut knob, a stepped Bass Cut knob and then an LPF toggle switch (on/off).

It's worth noting that the additive controls (Bass Lift, Mid/Hi Lift, etc) rotate clockwise whilst the two reductive controls (Mid and Bass Cut) rotate counter clockwise - an intuitive design feature.

After the EQ comes the Attitude section, made up of the valve mode toggle switch (Triode or Pentode) and the 6-step red chicken-head Attitude knob. Finally, there is the Output control (again, goes up to 11), a three LED signal indicator (Signal, OK and Overload) followed by the +48v switch, power switch and light.

The +48v toggle switch is of the 'pull-on' variety which prevents accidental powering up when ribbon mics are plugged in - a very useful touch.

In use

Good design is one thing, but as with all audio gear the sound quality is where you want to spend your money, and in this area the Rooster rules the coop.

There is plenty of aggression courtesy of the Attitude section, but unlike its namesake this aspect is highly controllable and a whole range of tones can be achieved. The ECC81 (12AT7 in the US) valve based preamp, which uses a Sowter 1200Ω transformer for the mic input, has plenty of clean gain and a clarity across the entire frequency range that effortlessly translates transients and complex mid frequencies.

With Attitude set low (1 or 2) there is plenty of clean gain available between the input and output gain knobs so you can get a healthy level from ribbon mics on relatively quiet sources such as picked acoustic guitars, and in this case the quality of the preamp really shines through making EQ adjustments simple and slight.

The Mid/Hi Lift control offers two broad bell boosts at 2.5kHz or 4kHz with the third 'Hi' setting providing a gentle HF shelving EQ. The Bass Lift, Bass Cut and Mid Cut have no frequency selection controls, but the 'vari slope' approach used in the circuit does shift frequency and Q with gain boosts/cuts. Though this may seem restrictive on paper, in use it makes tone shaping simple and intuitive.

The Rooster works well when cuts and boosts are used simultaneously to create smooth curves across the frequency range. The Bass Lift is broad and can be used to gently enhance the low range and even with extreme settings it does not cloud the bass response and turn the source to mush. Used with the Bass Cut it can really lift the punch of a bass guitar or kick drum.

The 2.5kHz and 4kHz Mid/Hi Lifts are broad enough to lift the presence of a whole range of sources without zoning in so much that it creates a harsh mid range. The Hi setting here is also subtle enough to pull forward the upper ranges without adding any brittle qualities to the source.

Article Source Music Radar.com

Music Radar.com ( Press )

Future Publishing is the owner of MusicRadar.com and publishes over 150 magazines and websites worldwide. 

 

Comments (0)

Subscribe to this comment's feed

Show/hide comment form